ADX-140 Specifications

Microphone/Line Inputs Four balanced. Phantom power available
Preamp Gain (total path) +25dB to +70dB
Line Input Impedence 20K Ohms, balanced to ground
Common Mode Rejection Mic Input/45dB Gain = 100dB, Line In = >70dB
Freq Response (All Paths) 20-20KHz, +/- 0.5 dB
Microphone Channel EIN 125 dB, bandwidth-limited to 25KHz
System Signal/Noise 100 dB below peak level, bandwidth-limited to 25KHz
A-D and D-A Conversion 24-bit, 48KHz
Digital Processing 24-Bit, 48KHz, via dual-core 32-bit DSP
IFB Outputs 2 channel wet RTS-format or single-channel dry +4dB nom.
IFB DC Current Sufficient to power two RTS IFB beltpacks
PL Interface 2 channel wet RTS-format. DC current to support 3 beltpacks
PL Trans-hybrid Loss Greater than 55 dB
Remote Control From ADX-2400, From rear-panel RS232, or GPI
Network Transmit Channels Six: Mic1, Mic2, Mic3 (TB1), Mic4 (TB2), PL1-TX, PL2-TX
Network Receive Channels Six: IFB1, IFB2, PGM1, PGM2, PL1-RX, PL2-RX.
Front Panel Switches Two-digit rotary ID switches. No other panel controls
System Addressing Two-digit rotary switches. Address 01-99
Network Interface 100baseT Ethernet (redundant RJ45 ports)
Ethernet Bandwidth Required Approximately 8 megabits/sec each direction per ADX-140
Power Requirements 48 Volts, 255 MA with no beltpacks. 350 MA with four beltpacks, or AC (95-250V/50-60Hz)
Cabinet Dimensions 19" Wide, 9" Deep, 1.75" High. (1 Rack Unit)
Weight Approx. 3 Pounds